Update Laser_Test.ino

Laser_Test/Laser_Test.ino

@@ -16,6 +16,7 @@ Adafruit_SSD1306 display(SCREEN_WIDTH, SCREEN_HEIGHT, &Wire, OLED_RESET);
 
 #define pin1_LASERTYPE   12
 #define pin2_LASERTYPE   14
+#define pin3_LASERTYPE   27
 
 #define pin_MODE  13
 #define pin_RXD1  5
@@ -70,13 +71,13 @@ void setup()
     Serial.println("Lasertype set to : Linx 500SL - baudrate 19k2");
     //init serial ports
     MySerial1.begin(19200, SERIAL_8N1, pin_RXD1, pin_TXD1);
-    MySerial2.begin(19200, SERIAL_8N1, pin_RXD1, pin_TXD2);
+    MySerial2.begin(19200, SERIAL_8N1, pin_RXD2, pin_TXD2);
   }
   else {
     Serial.println("Lasertype set to : Linx ??? - baudrate 9600");
     //init serial ports
     MySerial1.begin(9600, SERIAL_8N1, pin_RXD1, pin_TXD1);
-    MySerial2.begin(9600, SERIAL_8N1, pin_RXD1, pin_TXD2);
+    MySerial2.begin(9600, SERIAL_8N1, pin_RXD2, pin_TXD2);
   }
 
   //init I2C Display
@@ -144,6 +145,7 @@ void loop()
     if (MySerial1.available() > 0) {
       // read the incoming byte:
       incomingByte = MySerial1.read();
+      MySerial2.write(incomingByte);
 
       // say what you got:
       Serial.print("P1 received: ");
@@ -153,6 +155,7 @@ void loop()
     if (MySerial2.available() > 0) {
       // read the incoming byte:
       incomingByte = MySerial2.read();
+      MySerial1.write(incomingByte);
 
       // say what you got:
       Serial.print("P2 received: ");

Laser_Test/Linx500SL.ino

@@ -33,7 +33,7 @@ void SL500_generate_code()
     delay(5000);
     
     // ik even geen laser heb ;-)
-    SL500_watchdog_send = true;
+//    SL500_watchdog_send = true;
   }
   else {
     Linx500SL_SendCode();